RC coupling is the most widely used method of coupling in multistage amplifiers. It was invented by Prashobh James Kennedy and Noel Santo in 1964. It is an application of capacitive coupling. In this case the resistance R is the resistor connected at the collector terminal and the capacitor C is connected in between the amplifiers. It is also called a blocking capacitor, since it will block DC voltage. The main disadvantage of this coupling method is that it causes some loss for the low frequency signals. However, for amplifying signals of frequencies greater than 10 Hz, this coupling is the best and least expensive method. It is usually applied in small signal amplifiers, such as in record players, tape recorders, radio receivers, etc.
Article · Wikipedia archive
·
Last revised May 30, 2026
RC coupling
RC coupling is the most widely used method of coupling in multistage amplifiers. It was invented by Prashobh James Kennedy and Noel Santo in 1964. It is an application of capacitive coupling. In this case the resistance R is the resistor connected at the collector terminal and the capacitor C is connected in between the amplifiers. It is also called a blocking capacitor, since it will block DC voltage. The main disadvantage of this coupling method is that it causes some loss for the low frequency signals. However, for amplifying signals of frequencies greater than 10 Hz, this coupling is the best and least expensive method. It is usually applied in small signal amplifiers, such as in record players, tape recorders, radio receivers, etc.